|Surpassed rugged industry
|All Land Pride Cutters have been designed and tested and meet rigorous voluntary
|Saves customer set-up time and money.
|5 Year gearbox warranty
|Shows confidence in gearbox integrity.
|160 HP Divider gearbox
and 75 HP wing gearboxes
|A rugged heavy built gearboxes capable of handling heavy cutting applications.
|Gearbox Seal Protection
|Gearbox bottom seal protection for longer bearing life.
|Input driveline: Cat. 4 CV
|Driveline is matched just right for capacity of tractor. Constant velocity (CV) U-joint
allows for 80 degree turns without doing damage to the driveline.
|Easy greasable drivelines
|Drivelines have access holes for greasing the U-joints and to grease the inner profiles.
|2 Plate slip-clutch
|Protects drivelines and gearboxes by slipping clutches rather than twisting the driveline
when impacts are encountered.
|15,000 FPM High blade tip speed
|Allows clean cutting of material and even distribution.
|6" Blade overlap
|Eliminates skipping during turns.
|11 1/4" Deck height
|Handles heavy cutting, which reduces balling-up of cut material under the deck.
|3/16" Gauge Stump jumper backed
with a 1" thick mounting bar
|Allows cutter to slide over obstructions protecting gearbox output shaft & bottom seal.
|10 Gauge smooth deck top
|Reduces accumulation of debris and is easier and faster to clean.
|1/4" Plate side skirt
|Reduces debris piercing possibilities.
|Low hitch weight
|Less drawbar wear. Less ballast required. Works well with lighter tractors.
|Dual remote hydraulics
|Easy to operate. Fits most tractors, only two duplex outlets required to lift wings and
change cutting height separately.
|Hinged wing sections
|Allows cutter to follow terrain. Ideal for rough ground where hillsides, ditches and
hollows can cause uneven cutting. Wings will hinge 20o down.
|7/8" Solid hinge rods
|Gives great strength to the cutter from front to rear, and in the hinge area itself.
|Wing transport locks
|Holds transport wings in the folded-up position in case of hydraulic pressure loss.
|Enclosed front to rear dual leveling
|Dual leveling rods enable the cutter to pull equally on the rear axle during travel over
rough terrain. Many competitors only use one leveling rod.
|5-Bolt hubs makes the wheel assembly more durable and longer lasting.
|Drain holes in wheel rims
|Allows water to drain from wheels mounted on folded-up wings.
Helps prevent paint deterioration and rusting to the wheel rims.
|Spring-cushioned lift cylinder
|Cushions loads on drawbar.
|Replaceable wheel spindles
|Wheel spindles can be replaced when damaged without replacing the entire axle.
Simply remove two bolts to replace damaged spindle.
|7/8" Leveling rods
|Large diameter leveling rods provide superior supporting strength over rough terrain.
|Gives better cushion while transporting and provides flotation in soft ground.